|Topic Review (Newest First)|
|11-15-2010 02:10 PM|
|11-15-2010 01:07 PM|
Originally Posted by DC5R View Post
Where would I obtain longer ladders? Would that have to be from Ride/K2 or are toe ladders usually interchangeable?
|11-15-2010 01:04 PM|
Originally Posted by JoeR View Post
|11-15-2010 10:33 AM|
Here's my opinion regarding your questions.
|11-15-2010 10:08 AM|
My answer to question 2 is "probably not." For years I used a Ride SPi L when I probably would have been better off with an XL. My boots were crammed into the bindings with essentially no clearance at all on the sides, but the setup worked fine and I don't think created any extra pressure to an uncomfortable degree. However, you must realize that no one can answer this question for you definitively. It's like asking someone else whether your underwear is too tight.
With respect to question 3, it'll work, but is not optimal.
|11-14-2010 11:23 PM|
|rainboarding||Anybody got the answer(s) to any of these questions?|
|11-13-2010 10:19 PM|
Originally Posted by Starter View Post
That's too bad about mondo sizing I guess you won't know till you bring them in-store, which I did just thought I'd share my impressions.
I went to my local REI with my left boot and tried fitting into size L Ride EX's (no Ride RX or Delta) and size L K2 Indy's (no Formulas) and the size L was able to barely accommodate my boot width-wise. Both sat pretty much flush to the sides.
1) Can anyone confirm that the Ride EX and K2 Indy chassis dimensions are the same as that of the Ride RX & Delta MVMNT, and K2 Formula, respectively?
2) If there is no space between the binding sides and the boot, will these create pressure points serious enough to notice?
3) My boot fit into the bindings, but I was only able to ratchet the toe strap down three notches on the toe ladder max. Will this be an issue?
|11-07-2010 07:50 PM|
|Starter||i wear a size ten boot but that didnt even garentee a size l i had to go to an xl in ride bindings what kind of boots are you using might i ask? and the mondo sizing wont work because its the outside of the boot not the inside which matters|
|11-07-2010 07:33 PM|
Binding sizing to boot size
So I'm looking at a Ride RX size L (9-11) binding. I wear a size 11 boot. I am aware that the true size of a boot varies a lot between brands, but what about mondo sizing? The Ride website shows that size L fits 27-29 CM boots, and my boot is a 29 CM boot. Does that STILL not assure me of being able to fit O.K. in a size L binding?
On another note, does the weight of a binding increase with size enough that I would notice?
thanks for any input you guys might have.