|Topic Review (Newest First)|
|12-22-2010 05:03 PM|
|john doe||I was experimenting with this yesterday. My only complaint about my Buck Ferton is the shallow side cut make carving large and long. I pulled my knees in and found I got faster shorter carves.|
|12-22-2010 10:08 AM|
I think I saw this in the SnowProfessor video site. Perhaps it was in carving. I forgot. I think the instruction is wrong though. You don't "extend your legs". You bring your knees together. Assuming your boot is hard enough I guess, you should be able to decrease the "on-tilt sidecut-radius" a little bit. I tried it and I don't think it does anything for me. Maybe it's my setup or it's more effective in hard-booting...or "soft boarding".
I know what you mean by the terms though. It should be like "roll"...as in the standard craft terminology.
|12-22-2010 04:51 AM|
Originally Posted by Snowolf View Post
|12-22-2010 12:43 AM|
Originally Posted by Bones View Post
Practice moving the snowboard edge to edge by applying pressure to the edge of the snowboard. Tilt the board less than in the first exercise and now focus on trying to bend the snowboard to make it change directions. To do this, assume a low stance posture and then extend the legs to press the edge into the snow. This should bow the the board, increasing it`s camber at this point and decreasing turn radius.
Apply these tactics to long radius turns on the flats with some momentum. First, tilt the snowboard and balance on it`s edge. Second, bend the snowboard by pressing on the edge as described above. The student`s goal is not speed or tight turns at this stage, focus on skid avoidance.
|12-21-2010 11:25 PM|
Originally Posted by onthefence View Post
|12-21-2010 11:13 PM|
Difference between Tilting and Bending?
Tilting the board vs Bending the board? From what I understand you should be tilting first, then bending? No idea how they are different...