|Topic Review (Newest First)|
|02-22-2011 11:46 PM|
|freshy||In case your still having trouble, the slots on the baseplate should be going toe to heel side, put in the screws but don't tighten them, do up your boots tight and strap them in, CENTER THE BOOT and take a look from whichever angle either head on or base, slide binding forward or back and look again to make sure the boot is centered, tighten screws all the way when you got the boot centered.|
|02-22-2011 11:22 PM|
|PanHandler||tape measure is the way to go for sure.|
|02-22-2011 10:51 PM|
Originally Posted by Smokehaus View Post
|02-22-2011 10:50 PM|
|Smokehaus||I usually just measure|
|02-22-2011 10:46 PM|
|jyuen||might be easier to tell if you look at the overhang from the bottom of the board. that's what i do.|
|02-22-2011 08:53 PM|
|tj_ras||Id say a 1/4 or 1/2 inch to the toeside and youll be golden pony boy.|
|02-22-2011 08:48 PM|
Originally Posted by fayewolf View Post
|02-22-2011 08:06 PM|
too another shot kind of like your pic to hopefully show a better angle?
move it more still?
|02-22-2011 07:55 PM|
|Grasschopper||Looks better but maybe still too much to the heel side. Kind of hard to tell from these photos...try to get down flush with the deck and right down the centerline of the board like the photo I attached. It will be easier to see there.|
|02-22-2011 07:43 PM|
moved them up a bit, is this better?
|This thread has more than 10 replies. Click here to review the whole thread.|