|Topic Review (Newest First)|
|04-19-2011 08:44 PM|
|BurtonAvenger||That's not a flow issue, that's not even a binding issue, it's called check your screws.|
|04-19-2011 08:25 PM|
I'm sorry but what has this got to do with Flows specifically? Arn't we just talking about the bolts that hold the base plate down fastening the bindings to the board? Except burtons channel thing isn't it pretty much the same for most other bindings? Educate me.
How does replacing your bindings stop the bolts coming loose?
|04-19-2011 07:54 PM|
Originally Posted by AcroPhile View Post
He still loves his flows, but I have replaced mine because I got tired of the bolts working themselves loose.
|04-19-2011 12:13 PM|
Originally Posted by Donutz View Post
|04-17-2011 07:35 PM|
|BurtonAvenger||Yanked the binding right off and left the board on the load ramp with the disk.|
|04-17-2011 07:30 PM|
Originally Posted by BurtonAvenger View Post
|04-17-2011 07:04 PM|
Well could be like the kid that was in front of me getting on the lift and have your front binding pull off.
|04-17-2011 04:29 PM|
I did the same thing once, the rear binding came off while I was doing a speed check.
I sat there in the middle of the mountain trying to re tighten my bindings with my house keys.
|04-17-2011 04:10 PM|
Originally Posted by slyder View Post
|04-17-2011 12:16 PM|
I have never had an issue with the base plate screws on my NXT-ATSE's I wax my board every 3 outings so I'm always loosening them to wax and they have always been tight.
I did have a buckle strap loosen up but it was a fast fix at the base of the hill.
Glad you didn't loose the binding while you were riding. That could have hurt bad depending where you were at the time.
I hope you didn't loose the faith in them....
|This thread has more than 10 replies. Click here to review the whole thread.|