|Topic Review (Newest First)|
|06-27-2012 03:27 AM|
|Frootluips||Thanks timmytard. I used your advice and it worked like a charm.|
|06-14-2012 12:05 PM|
I like the lepage stuff that comes in a syringe. It's two tubes meeting at one nozzle. You squeeze the two parts out onto a piece of plastic, or into the core of the board, use a toothpick to mix the epoxy REALLY well, then rest the board in a position that will allow the epoxy to sort of sit in its final position.
Generally the stuff is quite liquid when working with it, so you want to make a cavity for it to fill, then pour it in and let it cure. Then you can sand, file, shave it down and paint if need be. I repaired board this way in the mid-90's and it's still holding up.
|06-14-2012 10:44 AM|
I was being cereal. I use the cheap shit all the time.
I like to use bbq skewers, they are bamboo & pretty tough.
Sand it down to a flat point & you should be able to cram it in pretty deep.
Use the flat part to smear epoxy like a butter knife.
|06-14-2012 07:02 AM|
Originally Posted by Frootluips View Post
|06-14-2012 03:32 AM|
Originally Posted by IndraRipper View Post
Originally Posted by timmytard View Post
|06-13-2012 04:05 PM|
Go to the dollar store & grab some for a buck, it'll work.
|06-13-2012 01:23 PM|
You really want to use epoxy, if it as a large splinter I use flexible epoxy so it doesn't fall off when you flex the board.
Flex-Epoxy toughened epoxy resin adhesive glue impact resistant black plastic metal high strength
|06-13-2012 12:10 PM|
Snowboard Layer Seperation
My snowboard is separating between the top sheet and the core layers. I have read around that epoxy will do the job. But that is very expensive. I do have some Pasco Fix adhesive though. Would I be able to use that to fix the separating layers?