|Topic Review (Newest First)|
|01-26-2013 05:48 PM|
|Weipim||damn, 824 for the coal XT....|
|01-26-2013 01:13 PM|
Originally Posted by Weipim View Post
it's located in Austria, i'd highly recommend that shop btw - professional service + they know how to take care of their customers
|01-26-2013 01:02 PM|
|01-26-2013 12:14 PM|
Originally Posted by poutanen View Post
|01-26-2013 12:04 PM|
|01-26-2013 10:36 AM|
ok i made some adjustments.. moved bindings one screw back, adjusted ankle straps as pou said, adjusted forward lean and made some highbacks rotation (not sure if i need it)
boots are almost perfect centered, it's going over the edge like 2.5 - 3 cm on both toe and heel and gas pedals are not going over the egde anymore
all photos are made while wearing boots, hope they are good now :
what you guys think?
|01-26-2013 01:24 AM|
Is the ankle strap already at it's max adjustment? It seems like you're only engaging about 5 teeth which probably won't be enough on the hill. I'd try to get that strap centred on both sides of the boot if possible.
Yeah you don't really want to toe or heel of the baseplate/gas pedal hanging over the edge.
Wiredsport has a good writeup somewhere of binding adjustment. Basically you want to strap in a laced up boot, then get the board on each edge and check the angle it'll reach before the toe or heel hits. Make adjustments until those angles are as close to equal as possible.
|01-26-2013 12:43 AM|
both boots and straps are tighten on the first picture actually
anyway i will move bindings one screw down, wear the boots and try to make some better photos later
in short, boots should be symetrical to the board, but can pedals go over the front/back edge? on the last photo gas pedal is going a bit over the edge, is it right or should i move it back a bit? is there any rule for this?
|01-25-2013 07:36 PM|
Either wear the boots for the pictures and strap in or at least tighten both the boots and straps.
|01-25-2013 06:40 PM|
hi ! parcel came today, everything is perfect, including boots
but now i need some serious help since i have no idea if i'm doing things right.. it's the first time i'm setting bindings up
here are some photos, hope they are good enough :
my boots size is 14
hell hoop and hell piece is moved back to maximum. i read that back of the baseplate shouldn't be out of the board, but it can be a bit on the front
anyway it's not symetric at all, should i move my bindings one/two screws down? i think it's the main problem for now, but maybe you will find something else wrong as well
|This thread has more than 10 replies. Click here to review the whole thread.|