|Topic Review (Newest First)|
|12-02-2012 07:06 PM|
|Skinny Bam||Ya I wouldnt worry about it being exposed....just put some hardware in them if it bugs you|
|12-02-2012 06:32 PM|
|slyder||If I read my tap correctly 5mmx1.00|
|12-02-2012 05:41 PM|
my holes are partially exposed as well. no problem at all.
just lean it against a wall inside or outside as soon as you're finnished with it.
|12-02-2012 05:25 PM|
|authenticK||alright thanks for help guys,also what size finishing tap do i need?|
|12-02-2012 03:22 PM|
I do this with all our boards at the end of the year.
I also need to do this with many new boards as the glue and junk gets into the inserts not allowing the screws to go in cleanly or square. Lib Tech was the worst with junk from the building process gumming up the inserts.
My middle boys new Forum I just did this and took this pic last night cleaning out the inserts on a brand new board
|12-02-2012 03:18 PM|
Originally Posted by authenticK View Post
|12-02-2012 03:15 PM|
Originally Posted by grafta View Post
|12-02-2012 02:54 PM|
You could use a finishing tap to clean out the thread.
|12-02-2012 02:49 PM|
Originally Posted by alaric View Post
Originally Posted by Donutz View Post
|12-02-2012 02:12 PM|
Also, is the rust in the binding inserts that you want to use? If so, can you work it out by bolting/unbolting a few times?
Honestly, if it's positions you'll never use I'd just clean it, wd-40 it, and not worry. You'll replace the board before the rust will do any damage to the board itself. (Unless you're planning on re-selling it someday?)
If it's positions you need and you can't clean it out, the board is a doorstop and should be returned asap.
|This thread has more than 10 replies. Click here to review the whole thread.|