|Topic Review (Newest First)|
|01-04-2013 02:11 PM|
Originally Posted by dice View Post
|12-30-2012 02:15 AM|
Just did mine on a 2013 Cartels few hours ago!!!
I was able to get the back side (-15) perfectly lined and parallel with the board edge. The front however (+21) , just slightly off!
I know your issue EXACTLY! That's what happened on my old P1.1. But with the new 2013 Cartels what I did was un-screw the outside 1st, rotate that side and tighten. Then move on to the outside screw, undo, rotate, then tighten. It sat over the heel cup PERFECT (to my surprise cause that was always an issue). Once done that, I did my +/- forward lean.
I hope this helps.
|12-30-2012 01:28 AM|
Originally Posted by hktrdr View Post
|12-30-2012 01:26 AM|
Originally Posted by timmytard View Post
|12-29-2012 12:35 AM|
Having similar concerns with my new Genesis bindings on the NS Cobra. When I rotate the highback to parallel the board and then try to tighten it...it loses the parallel or doesn't sit all the way in the heel cup.
Is it worth having a shop set them?
|12-28-2012 03:01 AM|
I think I know what he means? I was just fuckin' around with mine a week ago.
When you rotate the highback most or all the way, it doesn't sit pretty.
& after a few re-writes, this is pretty hard to accurately explain
It's so twisted, you have to apply force to get it to sit back on the heel cup, not a lot of force, but enough, that when released it pops out
|12-27-2012 06:06 PM|
Yeah, rotate your highback. There are screws that attach the baseplate to the highback (in the back of the baseplate) loosen those screws and rotate until the highback is parallel to the board.
that +/- thing I believe is for forward lean adjustment.
|12-27-2012 03:35 AM|
Originally Posted by kusanagi View Post
|12-26-2012 03:55 AM|
adjusting high back angle problem
I got a pair of new burton cartels.
My front leg has a 24degree stance angle. I am adjusting the highback of my front binding to make it become parallel to the board edge. But the highback is manufactured to a shape that it is parallel to the binding.
Should I use brutal force to make a 24degree shift and slightly change its shape?
but then the center of the high back (where the + - sign is) is 1cm above the rack even if I pushed it down it just recoils back up