|Topic Review (Newest First)|
|01-22-2013 02:28 PM|
Originally Posted by Casual View Post
I used to add a 3 degree base bevel and only detune between the bindings. But now I just bevel it and lightly detune the entire edge. No hang ups and not too rounded so it doesn't completely take away the edge.
|01-22-2013 01:34 PM|
Be smart about it, detune where you won't affect your riding too much and light bevel the effective edge. As menitoned above your still giving up some edge on ice and shit but w/e, you said its dedicated to park so. As far as washing out, if you get good board and body control you should be fine anyways, I'd say that more to do with your ability than your edge.
This is what I do.
Tips get filed down to round and then tapered into a slight bevel where it meets the effective edge. I keep that bevel to the outsides of my bindings and then taper back into filed off at 45 between the bindings slightly, not crazy amount but a few light runs with a file at 45 so its not sharp at all.
I have no issues riding my board like this anywhere on the mountain but be very careful on ice. That being said, you gotta have razor sharp edges to hold on ice anyways so nobody is in a better situation lol, I personally have always hated sharp edges park or no park.
|01-22-2013 12:57 PM|
Originally Posted by Joe Coffee View Post
|01-21-2013 02:20 PM|
Most likely. Depends on snow conditions and landings. Harder landings, you're gonna wash out more.
Like NE Rider said, I'd leave it the way it is.
|01-21-2013 01:43 PM|
|Joe Coffee||yeah this is a dedicated park board. will my landings be washy though on jumps?|
|01-20-2013 03:28 PM|
|Extremo||Depends on a few things. If you don't ride a lot of ice and this is a park/rail dedicated board then file the shit out of it. If you ride a lot of ice and/or take it all over the mountain then use a bevel with a light detune.|
|01-19-2013 11:44 PM|
|01-19-2013 11:01 PM|
Ok so I have super hero burton and was wondering if i should file the edges down so I dont catch? or should I leave them?