Join Date: Sep 2011
Location: Minnesota Summer--Utah Winter
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 14 Post(s)
If your talking about mounting on the board it's self I wouldn't trust a suction cup with the cold temps and banging around, just use one of your flat sticky mounts and then never think about it again.
I used the curved mount on my helmet and bit it a few times without issue , just make sure you follow mounting instructions, heat board\mount\helmet to at least room temp(70F) press hard\long and let it sit flat for 24 hours to set\cure whatever.
Good luck, also probably a good idea to check instructions from GoPro's site would hate to see you loose your cam.