Goggle fogging problem! - Page 3 - Snowboarding Forum - Snowboard Enthusiast Forums
User Tag List

LinkBack Thread Tools Display Modes
post #21 of 25 (permalink) Old 01-24-2012, 09:16 PM
comclovin's Avatar
Join Date: Mar 2009
Location: Colorado
Posts: 37
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
I've found in the past, that if the goggle doesn't sit on the bridge of my nose properly, I end up with a fogged lens on the inside due to a small gap on my nose. Not sure if that's the case here, but figure I'd share the thought.

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
- Ride Big!
comclovin is offline  
Sponsored Links
post #22 of 25 (permalink) Old 01-24-2012, 10:48 PM
hikeswithdogs's Avatar
Join Date: Sep 2011
Location: We've gone full Utard
Posts: 1,416
Mentioned: 6 Post(s)
Tagged: 0 Thread(s)
Quoted: 133 Post(s)
Blog Entries: 1
Originally Posted by KC10Chief View Post
I ALWAYS have problems with my goggles fogging. I started out with some cheap, Scott goggles. I think they were about $25. I recently upgraded to some Smith I/O goggles. The visibility is awesome. But they are fogging too. I bought some Cat Crap to put in them and have tried other anti-fog stuff to no avail. Finally, I realized that the problem may be my helmet. I have a Giro helmet. I don't know which one. I bought it at Sports Authority a couple years ago. I noticed that the top of my goggles fit perfectly against the front rim of my helmet. The Smith I/O goggles vent through the top. I'm guessing that the helmet is preventing the moisture from escaping. I was looking at getting a Smith helmet. Do they have vents in the front rim that would allow the moisture to escape from my goggles? I can't find any in the local area in my size. I'll have to order one. Thoughts?
I wear a facemask which causes moist air to flow up into my old goggles causing fogging even with my I\O's even though it was greatly reduced compare to my older Oakley Wisdom's

I recently bought a pair of Smith Turbofan Goggles and problem solved forever I have never once had a fogging issue, these things rock especially in combination with a never smith helmet.

Just don't forget to shut them off at the end of the day or else you run the single AAA battery out overnight

hikeswithdogs is offline  
post #23 of 25 (permalink) Old 02-15-2012, 04:27 PM
Junior Member
Join Date: Feb 2012
Posts: 1
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Thumbs up Snowboard Fog Wiper by Wide-i

On a different note, I use Snowboard fog wiper (by Wide-i) for my mask fogging problem. I have been using scuba mask fog wipers for my mask fogging under the water, and have been very happy with it. I don't have to take my mask off in the middle of diving to rinse the fog off from the mask. Recently when I found out that the Company also makes snowboard and ski mask version, I gave it a try, and I am very happy with these little fog wipers. You wipe using your index finger outside the mask/goggle, and inside fog gets wiped off from the mask! Easy!
Freestyle is offline  
post #24 of 25 (permalink) Old 02-15-2012, 06:43 PM
Senior Member
Join Date: Oct 2010
Location: Colorado
Posts: 119
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Smith helmets have little vents in front that are designed to help the goggles vent. I wouldn't put any more things (cat crap, etc) on the inside of the lens. It is treated from the factory not to fog. You can blot it with one of those little sponge/chamois things. Usually they fog because of something covering your nose-- face mask, etc. and warm air goes up.
sb60 is offline  
post #25 of 25 (permalink) Old 02-15-2012, 09:43 PM
Senior Member
uh oh a virus 2's Avatar
Join Date: Sep 2011
Posts: 124
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
I had a bad fogging problem too. The answer to my prayers was this wax called "Catcrap" - Real cats where used lol but really, this stuff works great. Just apply it to the inside of your lens, let it sit for about 15seconds, then wipe it off. It cost like $3 at our local shop.
uh oh a virus 2 is offline  

Quick Reply

Register Now

In order to be able to post messages on the Snowboarding Forum - Snowboard Enthusiast Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome