Whatever you Copied. Paste it here! - Page 3 - Snowboarding Forum

InfiniteEclipse · 10-26-2012, 05:30 PM

https://fbcdn-sphotos-f-a.akamaihd.n...78677811_n.jpg

SnowBrdScotty · 10-26-2012, 06:29 PM

1c:14:48:b6:bf:e3

qwezxc12 · 10-26-2012, 07:22 PM

Per AC 150_5340_30d,
4.3. TAXIWAY CENTERLINE, subsection c:
Longitudinal and Lateral Spacing. The lights are spaced longitudinally per Table 4-1 for
minimum authorized operations above and below 1,200 feet (365 m) RVR. Fixtures should be
installed so that their nearest edge is approximately 2 feet (0.6 m) from any rigid pavement joint.
Allow a tolerance for individual fixtures of ±10 percent of the longitudinal spacing specified to
avoid undesirable spots. However, a tolerance of ±2 ft (0.6 m) is allowed for fixtures spaced at
12.5 ft (4 m). Displace centerline lights laterally a maximum of 2 feet (0.6 m) (to the nearest edge
of the fixture) to avoid rigid pavement joints and to ease painting the centerline marking. Apply
this lateral tolerance consistently to avoid abrupt and noticeable changes in guidance; i.e., no
"zigzagging" from one side of the centerline to the other.

RFI 00017 answer directed the contractor to locate Taxiway “P” REL cores 12” off of Taxiway Centerline Joint. This lateral displacement places the edge of the REL fixture a maximum of 2 ft. per section 4.3c, above. In accordance with the directive to avoid “zigzagging”, the lateral displacement was applied not just to the fixtures impacted by the offset pavement slabs (R2D048 – R2D052), but to the terminal light at the 21R Centerline as well.
************************************************** *******

I'm in the middle of writing a design rationale for some Runway lighting work at Detroit Metro, and avoiding it by reading the forums... not very exciting.

poutanen · 10-26-2012, 07:31 PM

Quote:

Originally Posted by SnowBrdScotty

1c:14:48:b6:bf:e3

MAC address?!? lol

DrnknZag · 10-26-2012, 07:45 PM

Mystery Ranch Group Buy

Just happened to paste this elsewhere on the forum....I'll try again later for something more interesting.

Edge · 10-26-2012, 08:14 PM

e2ed9202bd144ca77d1735b2022ef2ee.png

Started a Pokemon playthrough, screencapped this moment to tweet out..

faridk89 · 10-26-2012, 08:38 PM

Quote:

Originally Posted by Edge

e2ed9202bd144ca77d1735b2022ef2ee.png

Started a Pokemon playthrough, screencapped this moment to tweet out..

Good call, I think its time to bring out the gameboy color and play some pokeman

mrjimyjohn · 10-26-2012, 08:40 PM

Heyeahyeahyeahyeah

StrattonRider · 10-26-2012, 09:11 PM

http://www.mycontact.fr/public/histo...0YOURSELF).mp3

I was trying to download this song. Don't judge!! It is catchy.

vltsai · 10-26-2012, 11:37 PM

https://sphotos-a.xx.fbcdn.net/hphot...60498048_n.jpg

10-26-2012, 05:30 PM	#21 (permalink)
InfiniteEclipse Stay Strapped Join Date: Jan 2009 Location: Toronto Posts: 1,116	https://fbcdn-sphotos-f-a.akamaihd.n...78677811_n.jpg __________________ Did she say Strap-in or Strap-on?

10-26-2012, 06:29 PM	#22 (permalink)
SnowBrdScotty Senior Member Join Date: Apr 2009 Location: So Cal Posts: 451	1c:14:48:b6:bf:e3 __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-26-2012, 07:22 PM	#23 (permalink)
qwezxc12 Senior Member Join Date: Oct 2010 Posts: 161	Per AC 150_5340_30d, 4.3. TAXIWAY CENTERLINE, subsection c: Longitudinal and Lateral Spacing. The lights are spaced longitudinally per Table 4-1 for minimum authorized operations above and below 1,200 feet (365 m) RVR. Fixtures should be installed so that their nearest edge is approximately 2 feet (0.6 m) from any rigid pavement joint. Allow a tolerance for individual fixtures of ±10 percent of the longitudinal spacing specified to avoid undesirable spots. However, a tolerance of ±2 ft (0.6 m) is allowed for fixtures spaced at 12.5 ft (4 m). Displace centerline lights laterally a maximum of 2 feet (0.6 m) (to the nearest edge of the fixture) to avoid rigid pavement joints and to ease painting the centerline marking. Apply this lateral tolerance consistently to avoid abrupt and noticeable changes in guidance; i.e., no "zigzagging" from one side of the centerline to the other. RFI 00017 answer directed the contractor to locate Taxiway “P” REL cores 12” off of Taxiway Centerline Joint. This lateral displacement places the edge of the REL fixture a maximum of 2 ft. per section 4.3c, above. In accordance with the directive to avoid “zigzagging”, the lateral displacement was applied not just to the fixtures impacted by the offset pavement slabs (R2D048 – R2D052), but to the terminal light at the 21R Centerline as well. ************************************************ ***** I'm in the middle of writing a design rationale for some Runway lighting work at Detroit Metro, and avoiding it by reading the forums... not very exciting.

10-26-2012, 07:45 PM	#25 (permalink)
DrnknZag Veteran Member Join Date: Feb 2010 Location: PNW Posts: 919	Mystery Ranch Group Buy Just happened to paste this elsewhere on the forum....I'll try again later for something more interesting.

10-26-2012, 08:14 PM	#26 (permalink)
Edge Senior Member Join Date: Sep 2012 Posts: 185	e2ed9202bd144ca77d1735b2022ef2ee.png Started a Pokemon playthrough, screencapped this moment to tweet out..

10-26-2012, 09:11 PM	#29 (permalink)
StrattonRider -LIFETIME MEMBER- Join Date: Sep 2012 Location: Wall, NJ and Stratton, VT Posts: 156	http://www.mycontact.fr/public/histo...0YOURSELF).mp3 I was trying to download this song. Don't judge!! It is catchy.

10-26-2012, 11:37 PM	#30 (permalink)
vltsai Member Join Date: Jan 2011 Posts: 39	https://sphotos-a.xx.fbcdn.net/hphot...60498048_n.jpg