Snowboarding Forum - Snowboard Enthusiast Forums banner

I too just made a back yard Jib

947 views 6 replies 4 participants last post by  kev711 
#1 ·
Boom, here it is. This was my project for the afternoon. Pretty simple, basic design. I made them low enough so I didnt need to have a jump/lip or anything. You can just ride at them and hop up. I also made them so the two ends can easily be secured together to make one long one.

Started out planing the base for the width of the poly


Added some legs, pretty simple


made the sloped one, same way I did the flat one. painted the top so I could get the sheet put down


top sheet screwed on. ill finish painting it soon.
 
See less See more
4
#6 ·
Looks good. Not sure what top sheet you used but if it's not super hard and slick you might wanna stick to just 50/50 and spinning off of it. If you try a board slide you'll evidentially catch an edge from it digging in. Remember your edge is a blade. Just be aware is all I'm saying and have a blast.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top