CMSbored

Arent most edges stainless? so its just surface rust and doesnt really matter?

C.B.

Stainless doesn't rust at all.

CMSbored

it does, but not as bad as plain steel, or as easily.

CheoSamad

I dont know if the DC PLY has stainless steel edges but I doubt it does considering it DID rust.

__________________
Crush a bit, little bit. Roll it up. Take a hit.

WasatchMan

I always wipe my board down with a towel after every session.

Does wonders.

C.B.

Well let me re-phrase, if you have rust issues you don't have stainless steel

nickwarrenn

Reviving an old thread, but whenever I'm done riding, I always seem to have snow on and around my bindings, although I do wipe the edges down, I'm scared that this snow will melt then rust the edges. I've tried to take the build up off, but it never all comes out of every cranny.

EatRideSleep

Funny that the email notification for this thread came through my phone just as I was wiping my board down before loading it into my truck last night haha.

Yeah so it's sort of impossible to get all the snow off the bindings. What I do is bang off/brush off as much as I can, wipe down the edges, load it up.

When I get home, I bring it in and rest it vertically against a wall (tail on a towel to collect water). Wipe it down again. Any melting snow or water from the bindings at that point will drain down to the tail and not lay on the edges. Air drying it this way helps also.