Need some feedback - Snowboarding Forum

permalink · 10-04-2009, 10:41 PM

Hey guys,

I recently purchased a brand new 2009 Sims Protocol. At the store, I was told that I must do the edges (at 10 degrees) and wax it before using it. At a different shop, I was told that since the board is brand new, there is no need to do so. I am planning to do parks in the northeast... Question is... Should I leave it alone since it is a new board? Should I just do the waxing? or Should I do both the waxing + the edges? Please advice...

Thanks in advance,

DaFreak

BoardTheSnow73 · 10-04-2009, 10:51 PM

Here's a sticky from the General Equipment Talk section:

http://www.snowboardingforum.com/gen...rd-repair.html

10-04-2009, 10:41 PM	#1 (permalink)
DaFreak Guest Posts: n/a	Need some feedback Hey guys, I recently purchased a brand new 2009 Sims Protocol. At the store, I was told that I must do the edges (at 10 degrees) and wax it before using it. At a different shop, I was told that since the board is brand new, there is no need to do so. I am planning to do parks in the northeast... Question is... Should I leave it alone since it is a new board? Should I just do the waxing? or Should I do both the waxing + the edges? Please advice... Thanks in advance, DaFreak

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-04-2009, 10:51 PM	#2 (permalink)
BoardTheSnow73 Senior Member Join Date: Apr 2009 Location: Boise, ID Posts: 169	Here's a sticky from the General Equipment Talk section: http://www.snowboardingforum.com/gen...rd-repair.html