Snowboarding Forum - Snowboard Enthusiast Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Anyone have any knowledge about what these lines are appearing below the surface of the bottom sheet of a newly purchased board at the nose.

Does it look like a defect? future failure?
 

Attachments

·
Reformed Creep-o-saurus
Joined
·
6,863 Posts
Hard to tell from the pics but are those cracks in the base?!? If so I'd warranty that right away. Not right at all...
 

·
Registered
Joined
·
3 Posts
Discussion Starter #5
Hard to tell from the pics but are those cracks in the base?!? If so I'd warranty that right away. Not right at all...
Place I purchased board from says they don't think its worth warranty hassel they don't think co will warranty unless complete failure.

The picture is the best I can get. the lines are below the surface appear to be splits or razor cuts on the underside of the bottom sheet (p-tex BASE) doesn't appear to reach through to the surface

I was hoping someone on this forum is familiar with the mfg process & may be able to shed light on what I am looking at.

It is a sintered base. Do they seem strips of p-tex together when they mfg these bases? these lines are spaced evenly.
 
1 - 6 of 6 Posts
Top