Snowboarding Forum - Snowboard Enthusiast Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter #1
I already have a general "help me choose bindings/board" thread here http://www.snowboardingforum.com/bindings/68258-upgrading-gear-after-10-years-stiff.html but wanted to ask specifically about Burton Channel (ICS) adapter plates for my old (circa 2001) Drake F-60 Bindings.

I can't seem to find a place that will have them. In fact, I find it hard to find stores that carry/sell Drake bindings at all (10 years ago they were the sh!ts, no?). It doesn't help that they are an Italian company, and I sent an email in English via their website, but no response yet... :/

1) They seem to have adapters for ICS in their current lineup (from what I gathered reading the threads on this forum).

2) However, do they use the same size/diameter/teeth as they did 10 years ago? If so, I could use their current disc. If not, I guess I'm forced to "upgrade" my bindings...

 

·
Registered
Joined
·
42 Posts
...IMHO

If you don't get the EST Bindings they kinda move around on you, its a little sketchy. I had an ICS board and used my old cartels with the adapter plate, I ended up trading the board for an 09.

I haven't dealt with them since 2010 though, good luck!
 

·
Registered
Joined
·
38 Posts
Discussion Starter #4
FYI I still haven't been able to find a place to get Channel adapter plates. Drake hasn't responded back, and the few places I've been to in the city don't have them and/or carry Drakes at all. :/ Bummer...
 
1 - 4 of 4 Posts
Top