Snowboarding Forum - Snowboard Enthusiast Forums banner
Cancel

Posts by ETM

Jump to Latest Follow
1 - 1 of 7 Posts
ETM

· Registered
Joined
·
2,432 Posts
#6 ·
The only thing that can disrupt the camber profile is heat. A lot of heat eg. 50-60°c can actually bring the resin back into a plyable state and the camber can be affected. basically dont put your board in a hot roof or car in the sun etc.
 
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
About this Discussion
6 Replies
6 Participants
Last post:
poutanen
Snowboarding Forum - Snowboard Enthusiast Forums
A forum community dedicated to all Snowboarding enthusiasts. Come join the discussion about equipment reviews, tips, traveling, gear troubleshooting, share photos, and more!
Full Forum Listing
Explore Our Forums
Boards Snowboarding General Chat Bindings Outerwear and Accessories Buy and Sell Snowboard Equipment
Top