Snowboarding Forum - Snowboard Enthusiast Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
137 Posts
Discussion Starter #1
ImageUploadedByVS Free1362704126.187146.jpg .
I'm planning on hanging this board on my wall diagonally and adding coat hooks for my room, but first I want to clean/polish/sand the board so that there are no more noticeable white spots where the bindings were. Any advice on what would be the best method?

Thanks
Glm


Sent from Verticalsports.com Free App
 

·
Reformed Creep-o-saurus
Joined
·
6,863 Posts
Any idea what the white spots are? Did the board sit in the sun for a long time with bindings on?

First thing I would try is just hot water and dish soap.

If that doesn't work, you could try mineral spirits but it's likely discolouration in the topsheet itself if dish soap doesn't work. If the topsheet is discoloured and you want it to look 100% for wall hanging, the only thing to do is sand the topsheet until the marks come out, and then try buffing.

To sand you'd start with something like 400-600 grit wet dry, and use it wet. Then move up to 1000 grit, 1500, 2000 and finally buff it with polishing compound and a buffer. Topsheets act like automotive clear finishes so generally you can take any car advice with regards to cut and polishing the surface.

On the other hand, I'm planning on wall mounting some of my retired boards, and I think war wounds add character, so I'll just wash them with dish soap and leave it at that. :D
 

·
Registered
Joined
·
922 Posts
yea, when my evo is done, itll hang right under my 09 Gnu DK..battle wounds and all. Theyre more than just a decoration..theyre memories.
 
1 - 3 of 3 Posts
Top