Snowboarding Forum - Snowboard Enthusiast Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Hey I was just wondering if I have too much toe and heel overhang. I have a burton process flying V 157 with large burton mala vita bindings and a 10.5 size burton photon boa boots. Ill attach some photos. Thanks!
 

Attachments

·
Premium Member
Joined
·
2,985 Posts
is that done with the two side screws that are also used to rotate the highbacks?
No, you can't adjust the heel cup with Burtons. I'd shift the binding a little more towards the heelside, but if you're not aggressively carving you should be fine.
 

·
Premium Member
Joined
·
2,985 Posts
towards the heelside? the heel is where im getting most of the overhang.
Sorry, only looked at one of the underside shots and assumed it was toe! I'd move them 1 hole towards the toeside then, should help even it out a bit.
 

·
Registered
Joined
·
6 Posts
Discussion Starter #8
ok yea ill give it a shot, hopefully it wont give me the opposite problem of toe hang lol
 
1 - 8 of 8 Posts
Top