Snowboarding Forum - Snowboard Enthusiast Forums banner

Too big bindings for boots?

609 Views 7 Replies 4 Participants Last post by  Nivek
I think my boots (vans hi-st) are too big so have ordered burton 1 size smaller to see how they fit. I've also put them on my bindings (union strata) and I think I need to go size down with bindings too. Am I correct?


See less See more
1 - 4 of 8 Posts
What is your boot size and what is your binding size?
Union strata size Large. Vans Hi-St UK 9.5, US10.5.
Burton's are 8.5 UK.
Feet: mondo 27.5 cm +/- 2-3mm depending on foot, quite wide.
Thanks! I worry that I may not sell both boots and bindings and they were only used for less than 10 days. So, I'll start with boots and if I sell them I'll buy smaller ones.
You'd be better with the next side down (medium) but will get away with this. Have a look at the Union binding finder in the support section of their website.
That's the plan but these bindings are almost new so don't want to let them go too cheap.

You can slide the rear heel cup forward into the chassis frame which will push the toes a little bit forward on the gas pedal.
It's already (even for Vans uk9.5) full forward.
1 - 4 of 8 Posts