Snowboarding Forum - Snowboard Enthusiast Forums banner

1 - 10 of 10 Posts

·
Registered
Joined
·
6,277 Posts
If the parts jive, of course you can:thumbsup:

I have some old Hammer bindings(made by Rossi) I just swapped out the straps on it with my Burton C02's

Now my Frankenbinding is complete, let's just say...

"It's alive,:yahoo: it's alive:eusa_clap:"


TT
 

·
Registered
Joined
·
2,445 Posts
Frankenbinder.
The only issue I see is mounting the toe straps as burtons snap in and Im not sure how the unions work. Have a play and see what you come up with
 

·
Premium Member
Joined
·
3,553 Posts
Toe straps will work. Not sure about the Ankle straps. The t-nut and screw on the Union are pretty specific to their straps. You might have some play with the Burton strap but washers might help. It couldn't hurt to try.
 

·
Registered
Joined
·
845 Posts
Discussion Starter #6
I was thinking just pads and caps. No straps. Keep union straps and ratchets just change the ankle pad and toe cap.

Wasn't sure if that would mess up any certain tech of the binding , like fuck up toe response or ankle response.

You wouldn't think it would.......
 

·
Registered
Joined
·
2,445 Posts
It wont fuck anything up, its just physically getting the parts to interchange. Pull them both apart and see what works.
 

·
Registered
Joined
·
845 Posts
Discussion Starter #8
Just tried and the buckle screws don't line up. Ill ride em for a while and if they work for me ill bastard them out then if I still feel the need
 
1 - 10 of 10 Posts
Top