Make sure your toe ramp is touching the boot as far out and low as possible (if its adjustable etc. Make sure boot is centered in binding. What angle and stance do you ride?

 

Turn your disk so the slots run edge to edge and not tip to tail, slide it forward or backward as needed then tighten down. Like Fluid mentioned pop the pins under the toe ramp and size them whatever size boot you're using as well. Also don't forget to adjust the heel cup, the allen screws don't need to be touched at all in doing this those are designed to hold it in and slide back and forth.

 

the 2-piece formulas have like 6 notches in the heelcup

 

thanks guys, will have a play around today

I ATM im riding about +15 -9

 

if you're riding a wide, but your feet are too small for it, why don't you try riding with your binding angles at 0

 

if you have 08s or 09s or whatever, unscrew the front 2 phillips head screws part way and slide the heelcup back and forth

 

Thanks, when I was looking at them thats what I assumed I would have to do, but for obvious reasons did't wana play around with them as I have no fuckin idea what I was doing, this being my first board/binding set still learning the set up

Thanks

 

yeah, riding with both feet at 0 would just be weird:dunno:

 

yeah had a little play around, has moved my foot a few mill not sure how much it will differ, but guess anything will help lol